Technology improvement of withdrawal ring of punched hole die for bearing ribbon cage;

軸承浪形保持架沖孔模退料環的工藝改進

Analysis of grinding method for bearing ring with double grooves;

雙溝軸承套圈溝道磨加工方法淺析

Design on Automatic Nondestructive Examination System of Axletree s Quality and Reseach on Intelligent Appraising;

軸承質量自動化無損檢測系統設計及智能評判方法研究

The bottom die with axletree configuration is designed.

依據圓柱斜齒輪幾何結構,設計出合理模具工裝;將凹模設計成軸承式凹模,當鍛件頂出時,凹模自動沿軸向自轉,鍛件被旋出凹模;采用三維剛粘塑性有限元法對其成形進行數值模擬分析,得到成形過程中的等效應力、應變分布圖以及載荷-行程曲線圖;模擬結果表明,坯料向齒腔充填時,齒根處等效應力、等效應變值較大;最后充填階段,齒頂處等效應力、等效應變值較大,載荷也出現陡增現象。

Improvement of Operating Technology of Bearings for Back-up Rolls on Medium Plate Mill;

中板軋機支承輥軸承使用技術的改進

The Research Actuality and Development Trends of Water Lubricated Bearings;

水潤滑軸承的研究現狀與發展趨勢

Property comparison of PM bronze bearings manufactured in Europe and North America;

歐洲與北美制造的燒結青銅含油軸承性能的比較

Analysis for Raising Life of Gear and Bear;

提高齒輪、軸承使用壽命的研究

The Design of Heavy Load Bear Lubricate Grease s Lifetime Testing Machine;

重負荷軸承潤滑脂壽命試驗機的設計

Change the Rubber Bearing into the Oil Bearing and Performance Analysis of It to the Small Turbine;

小型水輪機橡膠軸承改造為油軸承及性能分析

A low frequency rolling bearing fault diagnosis method based on local projective noise reduction;

基于局部投影降噪的低頻軸承故障診斷

According to characteristics of both the vibration signals and the stator currents when appering a fault in the rolling bearing of the induction motor,Park vector module signal of the three-phase current is calculated,and the envelope of vibration signals from the rolling bearing of the motor is analyzed.

根據感應電機軸承發生故障時的振動信號特性以及定子電流特性,求出三相電流的Park矢量模信號,并將其與電機滾動軸承振動信號經解調處理后的包絡信號進行融合分析,可以從振動信號與電流信號的融合譜圖中有效地提取軸承故障特征信息,并將其作為故障識別的依據。

Because the signal from rolling bearing is non-linear and non-Gaussian, here, the bispectrum analysis method is applied to the different types of rolling bearing and the different serious extent for the same bearing fault.

針對滾動軸承具有非線性和非高斯的特性,利用雙譜分析方法研究了不同故障模式下滾動軸承的雙譜特性以及同一故障類型在不同程度時的雙譜特性。