Study on the maximum tolerable bias(B) in mechanical coal sampler's performance testing for bias;

煤炭采樣機偏倚試驗中最大允許偏倚(B)的研究

The maximum allowable misalignment of the coupling is0.02 mm.

靠背輪找正的最大允許偏差為0.02毫米。

A error limitation of angle and chordal highness method is used to filtrate clouding point.

對大量數據的精減，利用角度和弦高的最大允許偏差法進行點云精減。

margin of error

最大容許誤差;最大允許誤差;誤差界限;誤差量

maximum permissible amount (MPA)

(金額) 最大允許量

The requirements for the intended use include such considerations as range, resolution, maximum permissible errors, etc.

預期使用要求包括：量程、分辨率、最大允許誤差等。

Edge processing deviation should be allowed to meet the norms.

邊緣加工允許偏差應符合規范的規定.

Quality of electric energy supply-Admissible deviation of supply voltage

GB12325-1990電能質量供電電壓允許偏差

maximum authorized mass of vehicle combination

汽車列車最大允許質量

maximum authorized amss of articulated vehicle

鉸接車最大允許質量

max allowable continuous working current

最大允許連續工作電流

largest permissible single chamfer dimension

允許最大單一倒角尺寸

maximum allowable tank filling limit

最大允許液艙充裝數量

The Maximum permissible error when the working frequency of Resistor is equal to or lower than the measurement frequency.

* 電阻箱的工作頻率等于或低于測試頻率上限時的最大允許誤差。

According to the allowance of production, the maximum error of measurement is used to determine the accuracy of the instrument.

根據生產所允許的最大測量誤差來確定儀表的精確度。

Deviation should be allowed to comply with the norms. The shear machine error should be allowed to meet the norms.

氣割的允許偏差應符合規范的規定.機械剪切的允許偏差應符合規范的規定.

maximum allowable working pressure

最大容許工作壓力;最大允許工作壓力;最高允許工作壓力

" Hot-rolled beam steel-Dimensions, shape, weight and tolerances"

GB/T706-1988熱軋工字鋼尺寸、外形、重量及允許偏差

" Hot-rolled channel steel-Dimensions, shape, weight and tolerances"

GB/T707-1988熱軋槽鋼尺寸、外形、重量及允許偏差